Ricoh FT8680 Service Manual page 287

LCT
6.5 PAPER END SENSOR, LOWER LIMIT SENSOR, PAPER
SIZE SENSOR, AND TRAY HEATER REPLACEMENT
[B]
[A]
1. Pull out the LCT.
2. Remove the side guides grips [A] (1 knob screw each).
3. Remove the paper tray bottom plate [B] (4 screws and 1 connector [C])
4. Remove the paper end sensor [D] and/or paper size sensors [E], and/or
tray heater [F] (1 screw and 1 connector each).
NOTE: 1. Take care not to damage the paper end sensor connector [C]
when the paper tray bottom plate [B] is removed.
2. Remember to connect the paper end sensor harness to the
connector [C] when installing the paper tray bottom plate.
[C]
A171R604.img
[F]
[A]
[D]
5-58
31 July 1995
[E]
A171R591.img