Ricoh FT8680 Service Manual page 153

31 July 1995 MOVING ORIGINAL SCAN AND BY-PASS FEED TABLE
[B]
[E]
[D]
A171D558.img
[A]
[C]
A171D557.img
After the 1st scanner is moved to the scan position (center of the exposure
glass), the inverter motor and the belt motor start to feed the original again.
At the same time, the sheet-through guide solenoid [A] and the original scale
solenoid [B] of the copier main body are energized to move the guide [C] and
scale [D] to the sheet-through position. The original is transported onto the
guide and the scale ready to be fed out.
When an original is placed on the sheet-through table, if the reed switch [E]
of the CFF (computer form feed) guide is not actuated (the guide is not in the
rear end position), a message is displayed advising the user to set the guide
at the rear end position.
2-129