Ricoh FT8680 Service Manual page 307

REGISTRATION AND TRANSPORT
8.7 TRANSPORT UNIT BELTS REPLACEMENT
[A]
A171R628.img
[I]
1. Remove the transport unit release lever [A] (1 screw) and middle inner
cover [B] (2 screws).
2. Remove the transport unit cover [C] (2 screws) and transfer and
separation corona unit [D] (1 connector).
3. Remove the positioning bracket [E] (2 screws), the grounding wire [F] (1
screw), and harness [G] (3 clamps).
4. Remove the transport unit [H] and transport tank [I] (4 screws).
5. Replace the transport unit belts.
NOTE: When reinstalling the transport unit, guide the transport unit right
of the guide [J] of the horizontal transport unit and insert the
positioning pin [K] in the hole.
[B]
[J]
A171R627.img
5-78
31 July 1995
[K]
[H]
[D]
[G]
A171R610.img
[F]
[C]
[E]