Ricoh FT8680 Service Manual page 276

31 July 1995
5.2 CHARGE CORONA WIRE AND CHARGE CORONA
CLEANER PAD REPLACEMENT
[B]
1. Remove the left inner cover and take out the charge corona unit (1
connector).
2. Remove the rear end block cover [A].
3. Remove the front end block cover [B] (1 screw) and unhook the tension
springs [C].
4. Remove the old corona wires [D] and cleaner pads [E].
5. Clean the corona casing and end blocks.
NOTE: Use water first and then use alcohol to remove toner remaining
on the unit.
6. Install the new cleaner pads and corona wires.
NOTE: Make sure that the corona wires are set in the grooves [F] of the
end blocks and between the cleaner pads correctly.
[C]
[D]
[F]
[E]
5-47
AROUND THE DRUM
[A]
[F]
A171R590.img