Ricoh FT8680 Service Manual page 236

31 July 1995
[A]
[B]
[F]
6. Insert the new exposure lamp into the lamp heater so that the two
terminal pins [A] are in a horizontal position and the lamp manufacturer
mark [B] faces the rear.
7. Set the right terminal pin [C] of the lamp into the center of the rear lamp
holder [D].
NOTE: Make sure that the pin is properly positioned on the terminal of
the rear lamp holder [E].
8. Set the right terminal pin [F] of the lamp into the center of the front lamp
holder [G].
9. Fix the front terminal while pressing it to the rear (2 screws).
NOTE: Take care that the lead wires are not pinched by the terminal.
10. Set the lamp pins by pressing and turning the lamp as shown in the figure.
[G]
5-7
OPTICS
[C]
A171R573.img
[E]
[D]