Table of Contents
Advertisement
Preparation (Modules)
Fig. 5: COMmander 8S
module
0
Terminal clamps (removable) for connecting to the S
ports 1-4 (see circuit board label)
RJ-45 socket for connecting to the S
LEDs for displaying the status of S
RJ-45 socket for connecting to the S
LEDs for displaying the status of S
A connector for switching the operating mode on the
S
port 1
0
A connector for switching the operating mode on the
S
port 2
0
A connector for switching the operating mode on the
S
port 3
0
A connector for switching the operating mode on the
S
port 4
0
DIP switches for terminators on the S
Changing the Operating Mode for Switchable Ports
Caution: Electrostatic charges can destroy sensitive
components.
Only a skilled electrician may open the casing and
perform installation work within an open casing.
Divert electrostatic charges from yourself before
touching the circuit boards with your hands or any
tools. To do this, touch a metal object, preferably
earthed, e. g. the earthing terminal of the PBX or
a computer housing.
Requirements
– Previous system planning
Note: The S
ports 5-8 on the COMmander 8S
0
module support only the operating mode S
20
COMmander 8S
0
port 1 including
0
ports 1 and 2
0
port 3 including
0
ports 3 and 4
0
port 1
0
0
internal.
0
Module Overview
0
DIP switches for terminators on the S
DIP switches for terminators on the S
DIP switches for terminators on the S
Terminal clamps (removable) for connecting to the
S
port 5
0
Terminal clamps (removable) for connecting to the
S
port 6
0
Terminal clamps (removable) for connecting to the
S
port 7
0
Terminal clamps (removable) for connecting to the
S
port 8
0
Status display LEDs for S
DIP switch for terminators on the S
A connector for attachment on the base circuit board
A connector for connecting to the front panel of 19"
casing variants
Steps to Take
1.
Remove the jumper for the port to be switched.
2.
Reinsert the jumper according to the desired
operating mode. The correct jumper setting can be
found on the circuit board label or the
page 21
or
Fig. 7 on page
Note: On a COMmander 4S
jumpers of two adjoining s
replaced by a single COMmander Autoswitch. The
COMmander Autoswitch (optional accessory from
Auerswald) adds an emergency equipment function
to the PBX. If this optional connector is mounted on a
COMmander 4S
needed for emergency communication in switched
from an internal S
port 2
0
port 3
0
port 4
0
ports 5-8
0
ports 5-8
0
21.
module (rev. 2), the
0
ports can also be
0
module, an ISDN telephone that is
0
port directly to the external S
0
Fig. 6 on
port
0
Advertisement
Table of Contents
