Table of Contents
Advertisement
The "Status" LED and the "Power" LED light up in
red and orange for several seconds/minutes
during the restart. See also the table on
If both LEDs light up in green again, the restart is
complete and the PBX is ready for operation.
Note: If the "Power" LED remains continuously lit in
red, an error has occurred. Please contact your
dealer or the manufacturer directly.
Further Steps
Check the firmware version.
Note: If the old configuration is still present, you have
held the "Alternate" button too long and must
therefore repeat the procedure.
Requirements
– Computer with a connection to the PBX web server
– PC application, D-channel decoder, installed as of
version 2.5.2 Beta
Note: The computer application can be installed from
the Auerswald Mega Disk.
– The IP address for the PBX is known (192.168.0.240
- factory setting).
Note: Remote recording/logging of a D-channel
protocol is also possible. For this purpose, please
refer to
Chapter Configuring the PBX Remotely via an
External S0 Port (PPP External) on page
of logging into the web interface, start the D-channel
protocol. Under "IP address", enter the local IP
address for the PPP configuration on the PBX (http:/
/192.168.193.240 is the factory setting).
Note: For external access from the Internet via a
router, the D-channel decoder uses port 42225. This
means that within the router configuration, port 42225
must be rerouted to the IP address of the PBX.
Note: When entering the IP address in the "Interface
selection" dialogue, it is possible that an existing port
will need to be omitted.
Steps to Take
1.
Start the computer programme.
2.
Click Start.
Page
71.
Starting the D-channel Protocol
63. Instead
Service and Maintenance
Fig. 65: LEDs and buttons
Alternate
Status
Reset
3.
Select the Interface IP.
4.
Enter the IP address for the PBX.
5.
Click OK.
The protocol log is displayed.
Note: If you would like to end a recording, click
Pause.
Fig. 66: "Power" LED
Power
79
Advertisement
Table of Contents
