Table of Contents
Advertisement
Next steps
Install the drive into the drive
Installing the drive into the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the
2. If installed,
remove the front
3.
Remove the drive
blank.
Steps
1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
2. Align the screw holes on the drive with the screws holes on the drive carrier.
3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with the screws.
NOTE:
When installing a drive into the drive carrier, ensure that the screws are torqued to 4 lbf-in.
Figure 34. Installing a drive into the drive carrier
Next steps
1.
Install the drive
carrier.
2. If removed,
install the front
Drive backplane
Drive backplane
Depending on your system configuration, the drive backplanes supported are listed here:
Table 37. Supported backplane options
System
PowerEdge R6525
carrier.
Safety
instructions.
bezel.
bezel.
Supported hard drives options
3.5-inch (x4) SAS, SATA backplane
2.5-inch (x8) SAS or SATA backplane
Installing and removing system components
59
Advertisement
Table of Contents
