Table of Contents
Advertisement
Steps
1. Align the front PERC module at an angle until the tray touches the slot in the system.
2. Press the front PERC module connector with the connector on the drive backplane until firmly seated.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
Next steps
1. Reconnect all the required cables.
2. If removed,
install the air
3.
Install the drive backplane
4. Follow the procedure listed in
Removing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. If installed,
remove the air
5.
Remove the drive
backplane.
6. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on the front PERC module.
2. Slide the front PERC module to disengage from the connector on the drive backplane.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
shroud.
cover.
After working inside your
Safety
instructions.
Before working inside your
cover.
shroud.
system.
system.
Installing and removing system components
67
Advertisement
Table of Contents
