Table of Contents
Advertisement
d) Loosen the captive screws 3 and 4 completely.
NOTE:
The captive screw numbers are marked on the heat sink.
2. Lift the heat sink from the system.
Figure 52. Removing a heat sink
Next steps
1. If you are uninstalling a faulty heat sink,
Removing the processor
Prerequisites
WARNING:
The heat sink may be hot to touch for some time after the system has been powered off. Allow the heat sink
to cool before removing it.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the heat
sink.
CAUTION:
You may find the CMOS battery loss or CMOS checksum error is displayed during the first instance of
powering on the system after the processor or system board replacement which is expected. To fix, go to set up option
to configure the system settings.
Steps
1. Using a Torx #T20 screwdriver, loosen the screws to release the force plate. The sequence to loosen the screws is 3, 2, and 1.
NOTE:
The screw numbers are marked on the force plate.
76
Installing and removing system components
replace the heat
sink, else
Safety
instructions.
Before working inside your
remove the
processor.
system.
Advertisement
Table of Contents
