Table of Contents
Advertisement
system board, you must supply the recovery key when you restart your system or program before you can access the
encrypted data on your drives.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the following components:
a.
Air shroud (if installed)
b.
Cooling fan modules
c.
Heat sink
d.
Processor
e.
Memory modules
f.
Expansion card risers
g.
IDSDM module (if installed)
h.
Internal USB card (if installed)
i.
OCP card (if installed)
j.
Power supply units (PSU)
k. Disconnect all cables from the system board.
CAUTION:
Take care not to damage the system identification button while removing the system board from the
system.
Steps
1. Using the system board holder and plunger, slide the system board towards the front of the system.
2. Lift the system board out of the chassis.
Figure 94. Removing the system board
Next steps
1.
Install the system
board.
116
Installing and removing system components
Safety
instructions.
Before working inside your
system.
Advertisement
Table of Contents
