Removing The Idsdm Module; Installing The Idsdm Module - Dell EMC PowerEdge R6525 Installation And Service Manual

Removing the IDSDM module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If you are replacing the IDSDM module,
NOTE: Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards
into the corresponding slots.
Steps
Holding the blue pull tab, lift the IDSDM module out of the system.
Figure 77. Removing the IDSDM module
Next steps
1. Replace the IDSDM module.

Installing the IDSDM module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Locate the IDSDM connector on the system board.
To locate IDSDM module, see the
2. Align IDSDM module with the connector on the system board.
3. Press the IDSDM module until it is firmly seated in the connector on the system board.
Safety instructions.
Before working inside your
remove the MicroSD
Safety instructions.
Before working inside your
System board jumpers and connectors
system.
cards.
system.
section.
Installing and removing system components 99