2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.
Optional serial COM port
Removing the serial COM port
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove expansion card
4. Disconnect the serial COM port cable from the connector on the rear I/O board.
Steps
1. Open the latch on the expansion card riser and slide the serial COM port out of the expansion card riser.
2. Disconnect the serial COM port cable from the serial port.
Figure 75. Removing the serial COM port
Next steps
1.
Replace the serial COM
After working inside your
Safety
instructions.
Before working inside your
riser.
port.
system.
system.
Installing and removing system components
97