Table of Contents
Advertisement
Figure 24. Installing the VGA module
Next steps
1. Route the VGA cable, close the cable latch, and connect the VGA cable to the connector on the system board.
2. Route and connect the right control panel cable.
3. If removed,
install the air
4.
Install the backplane
cover.
5. If installed,
install the front
6. Follow the procedure listed in the
Air shroud
Removing the air shroud
Prerequisites
CAUTION:
Never operate your system with the air shroud removed. The system may get overheated quickly, resulting in
shutdown of the system and loss of data.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
Hold the edges of the air shroud, and lift the air shroud out of the system.
NOTE:
The air shroud is required for the standard heat sink configuration. For the L-type heat sink configuration, air
shroud is not supported.
shroud.
bezel.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
51
Advertisement
Table of Contents
