Table of Contents
Advertisement
LOM card and rear I/O board
Removing the LOM card and rear I/O board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the system
board.
Steps
1. Using a Phillips #2 screwdriver, remove the screws that secure the LAN on Motherboard (LOM) card and rear I/O board to the
system board.
2. Holding the edges, pull the LOM card or rear I/O board to disconnect from the connector on the system board.
Figure 96. Removing the LOM card and rear I/O board
Next steps
1.
Replace the LOM card and rear I/O
Installing the LOM card and rear I/O board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the system
board.
Steps
1. Align the connectors and slots on the LOM card or rear I/O board with the connector and standoffs on the system board.
2. Press the LOM card or rear I/O board until firmly seated on the system board connector.
3. Using a Phillips #2 screwdriver, secure the LOM card or rear I/O board to the system board with screws.
Safety
instructions.
Before working inside your
board.
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
119
Advertisement
Table of Contents
