Quick Card
®
T-BERD
/MTS-2000 Modular Test Set
E4100 Module FTTH OTDR
This quick card exxplains how to connect to a fiber under test, configure FTTH mode test setups, run
tests, and analyze results with a VIAVI SmartOTDR or T-BERD/MTS-2000 and 4100-series OTDR module.
Equipment Requirements:
• SmartOTDR or T-BERD/MTS-2000 equipped with the following:
o Fiber Optics Software Release V16.22 or greater
o E4100 Series OTDR Module for T-BERD/MTS-2000
o FTTH-SMARTLINK Mapper icon-based OTDR
results option (FTTH-SLM license key required)
• Fiber optic cleaning and inspection tools
• 20-meter (or longer) fiber optic patch cord (Launch Cable)
• Optical Coupler to connect Launch Cable to Fiber Under Test
The following information is required to complete the test:
• Type of Connectors (SC UPC, SC APC, LC UPC, etc.)
• Distance unit (feet, meters, miles, kilometers)
• LOCATION: FTTH OTDR testing must be done from ONT to OLT direction. It can be either the
Second Splitter, NAP or at the Customer Premise (ONT Location)
Fiber Inspection Guidelines:
Inspect and clean (if necessary) both sides of every connection being used (bulkhead connectors, patch
cords, and OTDR port) prior to reconnection for each test. Using the P5000i or FiberChek Probe:
• Focus fiber on the screen. If dirty, clean the connector.
• If it appears clean, run inspection test.
• If it fails, clean fiber and re-run inspection test. Repeat until it passes.
Figure 1: FiberChek Probe
VIAVI Solutions
Figure 2: Image of Clean Fiber