Saving The Project - Viavi T-BERD/MTS 2000 User Manual

If Numbering is defined:
– On the parameter Start Fiber, press Edit Number soft key to enter the
number of the first fiber of the cable to be tested (Min 1 / Max 100).
– On the parameter Number Of Fibers, press Edit Number soft key to enter
the total number of fibers of the cable (Min 1 / Max 100).
If Labelling is defined:
– On the parameter Fiber Count, select the type of connector: Simplex /
Duplex / MPO (8/12) / MPO (12/12) / MPO (20/24) / MPO (24/24)
• Press the right direction key to enter a Comment if necessary, using the edition
keypad.
Figure 97 Cable SLM Setup

Saving the project

Once all configuration parameters are defined, save the project:
1 Press Save Project soft key (displayed when one parameter of the Cable Project
window is displayed).
2 In the Edition keypad opened, enter a name for the project and press Enter to
validate.
The project file (.prj) contains Acquisition / Alarms / Link / File parameters and is
saved in root disk or Harddisk under Project > EXPERT_OTDR > OTDR_SM or
OTDR_MM directory.
Cable SLM configuration
User Manual
Chapter 9 Cable-SLM option
Configuring the Cable-SLM project
77000010208 Rev. 012 163