Communications With Computer; Software Installation Procedure; Communication Between Adr-1500 And Computer - Thermo Scientific MIE ADR-1500 Instruction Manual

Communications
with Computer
Installation
Procedure
Communication
between ADR-1500
and Computer
Thermo Fisher Scientific
The computer requirements to install and run the software provided with
the ADR-1500 (pDR Port) is the following:
IBM-PC compatible
●
Pentium I or higher processor
●
Minimum operating system: Windows 95 and later
●
32 MB of RAM
●
10 MB hard disk drive
●
CD-ROM
●
VGA or higher resolution monitor
●
Thermo Fisher Scientific custom hardware and software provided with
ADR-1500 as standard accessories:
USB communications cable
●
Software CD (pDR Port)
●
Software
To install the Thermo Scientific provided software (pDR Port) in the
computer, proceed as follows:
Insert the CD labeled pDR Port into the computer
●
The install program should start automatically
●
The computer displayed install shield then serves to guide the rest of
●
the installation.
Please be sure to accept the Silicon Laboratories USB Driver
●
installation.
To effect the communication between the ADR-1500 (via the pDR Port
software installed in the computer) and the PC, proceed as follows:
Equipment Damage It is recommended to turn the instrument and
computer OFF before making a connection.
Connect the ADR-1500 to one of the computer's USB ports using the
●
USB communication cable
Key ON the ADR-1500; hold ON/OFF for 4 seconds
●
From your computer Start menu, or your computer desktop, open the
●
pDR Port software program. A multi-tabbed notebook display should
Guidelines and Instrument Layout
▲
MIE ADR-1500 Instruction Manual 2-19