7015 Model R24 - IBM RS/60000 Series Site And Hardware Planning Information

7015 Model R24

Dimensions
Height
Width
Depth
Weight
Minimum
(Configuration
dependent)
Electrical
Power source loading
(typical in kVA)
Voltage range (V ac)
Frequency (hertz)
Thermal output
(typical)
Power requirements
(typical)
Power factor
Inrush current³
Maximum altitude
Temperature
Requirements
Humidity
(Noncondensing)
Without tape drive
With tape drive
Wet Bulb
Requirements
Without tape drive
With tape drive
1,2
Noise Emissions
L
WAd
L
pAm
<L >
pA m
Impulsive or
prominent discrete
tones
Clearances
Install/Air Flow Maintenance of a proper service clearance should allow proper air flow.
Service (See service clearances for the R00 System Rack)
1. See "Noise Emission Notes" on page 336 for definitions of noise emissions positions.
2. Noise emissions data for the Model R24 CPU Media Enclosure are based on the following configuration: the
enclosure is mounted in a R00 System Rack with three 2.0GB SCSI Disk drives are installed, two SCSI Disk
Drawers with three 2.41GB disk drives installed, a power distribution unit is installed in the rack and the system is
operating in a nominal environment of 25°C (78 °F)
3. Inrush currents occur only at initial application of power, no inrush occurs during normal power off-on cycle.
44
Site and Hardware Planning Information
445.5 mm
445.5 mm
710.0 mm
51.3 kg
Operating
10 to 40°C
(50 to 104°F)
Operating
8 to 80%
20 to 80%
27°C (80°F)
23°C (73°F)
Operating
6.4 bels
N/A
49 dBA
No
Front Back
17.5 in.
17.5 in.
28.0 in.
112 lbs.
0.685
200 to 240 or -48V dc
50 or 60
2100 Btu/hr
615 watts
0.8 to 1.0
68 amps
2135 m (7000 ft.)
Left
Non-Operating
10 to 40°C
(50 to 104°F)
Non-Operating
8 to 80%
20 to 80%
27°C (80°F)
27°C (80°F)
Idle
6.2 bels
N/A
47 dBA
No
Right