IBM RS/60000 Series Site And Hardware Planning Information page 202

Securing the Rack
The following can be ordered by the customer as additional rack securing options for the Eserver pSeries
690.
v RPQ 8A1183 for attaching the rack-mounting plates to the concrete floor (non-raised floor)
v RPQ 8A1185 to attach the rack to a concrete floor when on a raised floor (9 1/2 inches to 11 3/4 inches
high)
v RPQ 8A1186 to attach the rack to a concrete floor when on a raised floor (11 3/4 inches to 16 inches
high)
Positioning the Rack:
Note: The customer should unpack the rack and position it in the room. If this has not been done, consult
the customer and the marketing representative as necessary.
To unpack and position the rack, do the following:
1. Remove all packing and tape from the rack.
2. Position the rack according to the customer floor plan.
3. Lock each caster wheel by tightening the thumbscrew on the caster.
Thumbscrew
Installing the Frame Kit: The following tables show the parts required for each of the tie-down kits (a
non-raised floor, short-raised floor, and a long-raised floor).
Rack Tie-Down Kits:
Item
Item 3 in illustration on page 186.
Item 5 in illustration on page 186.
Item 8 in illustration on page 186.
Item 6 in illustration on page 186.
Item 2 in illustration on page 186.
Item 7 in illustration on page 186.
Item 1 in illustration on page 186.
Item 9 in illustration on page 186.
Item 10 in illustration on page 186.
Item 1 in illustration on page 187.
Item 2 in illustration on page 187.
Item 4 in illustration on page 187.
Item 5 in illustration on page 187.
Item 3 in illustration on page 187.
Item 6 in illustration on page 187.
184
Site and Hardware Planning Information
11P4759 Frame tie-down Kit (Non-Raised Floor) (RPQ 8A1183)
Part Number
11P3527
11P3529
11P3530
11P3531
11P3532
76X4687
1624804
1621546
1622307
11P3528
05N6345
05N6344
21L4309
0130985
05N6346
Qty Description
2 Shipping bar (lower)
4 Hinge plate
2 Latch plate
2 EQ support
2 Shipping bar (upper)
2 Latch bolt
20 Screw (hex flange, 20mm, long)
8 Screw (hex, 25mm, long, hinge)
8 Washer (M8, hinge)
2 Plate lock-down
4 Spacer
4 Bushing
4 Washer
4 Washer
4 Bolt