Chapter 4. Physical Characteristics Of Displays; Powerdisplay 17 And Powerdisplay 20 - IBM RS/60000 Series Site And Hardware Planning Information

Chapter 4. Physical Characteristics of Displays

This chapter provides the physical characteristics for some of the displays that can be used with the
systems. The following information can help you plan for your displays. You need only do physical
planning for the displays you have ordered.

POWERdisplay 17 and POWERdisplay 20

POWERdisplay 17 with a maximum viewable image size of 409 mm (16.1 inches) measured diagonally.
POWERdisplay 20 with a maximum viewable image size of 486 mm (19.1 inches) measured diagonally
Dimensions
POWERdisplay 17
Height
Width
Depth
POWERdisplay 20
Height
Width
Depth
Weight
POWERdisplay 17
POWERdisplay 20
Electrical
Power source loading
(typical in kVA)
Voltage range (V ac)
Frequency (hertz)
Thermal output
(typical)
Power requirements
(typical)
Power factor
Maximum altitude
Temperature
Requirements
Humidity
Requirements
(Noncondensing)
Noise Emissions*
L
WAd
Clearances
Service Install so that air vents are not blocked.
* See "Noise Emission Notes" on page 336 for definitions of noise emissions positions.
414 mm
404 mm
450 mm
474 mm
480 mm
505 mm
22.5 kg
30.0 kg
100 to 120 or 200 to 240 (autoranging)
Operating
10 to 40°C
(50 to 104°F)
Operating
8 to 80 %
Operating
3.5 bels
Front Back
16.3 in
15.9 in
17.7 in
18.6 in
18.9 in
19.9 in
49.5 lbs
66.3 lbs
.38
50 or 60
480 Btu/hr
140 watts
0.7
3048 m (10,000 ft.)
Left
Non-Operating
1 to 60°C
(35 to 140°F)
Non-Operating
8 to 80 %
Idle
3.5 bels
Right
221