9112 Model 265 - IBM RS/60000 Series Site And Hardware Planning Information

9112 Model 265

The Model 265 is either a 1–way or 2–way system. The system can accommodate two processor cards,
one memory card with 16 DIMMs, and 5 PCI adapters. It supports six hot-swap DASD bays and one
floppy drive.
Dimensions
Height
Width
Depth
Weight
Minimum configuration
Maximum configuration
Electrical
Power source loading (maximum in
kVA)
Power source loading (typical in
kVA)
Voltage range (V ac)
Frequency (hertz)
Thermal output (maximum)
Thermal output (typical)
Power requirements (maximum)
Power requirements (typical)
Power factor - US, World Trade,
Japan
Inrush current²
Maximum altitude
Temperature Requirements³
Humidity Requirements⁴
(Noncondensing)
Wet Bulb
Noise Emissions¹
L
WAd
L
pAm
Impulsive or prominent discrete
tones
Install/Air Flow
Service
1. See "Noise Emission Notes" on page 336 for definitions of noise emissions positions. See noise emissions note
4.
2. Inrush currents occur only at initial application of power, no inrush occurs during normal power off-on cycle.
3. The upper limit of the dry bulb temperature must be derated 1 degree C per 137 m (450 ft.) above 915 m (3000
ft.).
4. The upper limit of the wet bulb temperature must be derated 1 degree C per 274 m (900 ft. ) above 305 m (1000
ft.).
5. Levels are for a single system installed in a T00 32 EIA rack with the center of the unit approximately 1500 mm
(59 in.) off the floor.
100 to 127 or 200 to 240 (autoranging)
Operating
16 to 32°C
(61 to 90°F)
Operating
8 to 80%
27°C (80°F)
Operating
6.1 bels
42 dBA
No
Maintenance of proper service clearance should allow proper air flow.
See service clearances for the 7014 T00 Rack
426 mm (16.8 in.)
215 mm (8.5 in.)
617 mm (24 in.)
35.5 kg 78 lbs.
43.1 kg 94.8 lbs.
0.40
0.30
50 or 60
1306 Btu/hr
979 Btu/hr
384 watts
288 watts
0.96
70 amps
2135 m (7000 ft.)
Non-Operating
10 to 43°C
(50 to 109°F)
Non-Operating
8 to 80%
27°C (80°F)
6.1 bels
41 dBA
Chapter 2. Physical Characteristics of Systems
Idle
No
213