Ethernet; Infra Tab - Lightware UMX-TPS-TX100 Series User Manual


  
5. Software Control - Lightware Device Controller
5.8.4. Ethernet
Two ports are displayed in the Ethernet settings: Local, CPU, and TPS. You can check the status of the
Ethernet line by each ports: the speed and the duplexity of the connection.
The following settings are available for the local port:
Enable / disable the port;
▪
Reloading factory defaults.
▪
ATTENTION! If the Ethernet port is set to disabled, this may break the connection with the device.
INFO: CPU Ethernet port cannot be disabled.
Ethernet tab in Control menu
UMX-TPS-TX100 series – User's Manual
5.8.5. Infra Tab
ATTENTION! The device has no built-in Infrared receiver and transmitter. For the complete usage attach
an IR emitter unit to the IR OUT and an IR detector unit to the IR IN connectors.
Infra-Red (IR) receiver and transmitter options can be found on this tab. There are three submenus are
available under it: IR codes, Ports, and Clear all IR codes.
IR Codes
User can set the name of the IR code, the fingerprint (hash), and the repeat timeout in ms, as well as actions
can be ordered to each IR codes.
IR codes window in Control menu
54