Tps Video Output; Analog Audio Inputs - Lightware UMX-TPS-TX100 Series User Manual


  
5. Software Control - Lightware Device Controller
5.5.4. TPS Video Output
Click on the output port to display its properties. The most important
information and settings are available from the panel.
Port properties window of TPS video output
UMX-TPS-TX100 series – User's Manual
Available settings:
▪ Mute/unmute the port;
Lock/unlock the port;
▪
Autoselect settings: enable / disable, mode, and priorities. (See
▪
more details about Autoselect feature in The Autoselect Feature
section);
Signal type: Auto / DVI / HDMI 24 bit / HDMI 30 bit / HDMI 36 bit
▪
- The outgoing signal format can be selected by a drop-down
menu;
HDCP mode: Auto / Always - The transmitter forces the source
▪
sent the signal without encryption if the content allows when
Auto mode is selected;
Power 5V mode: Auto / Always on / Always off - The setting lets
▪
the source and the sink devices be connected – independently
from the transmitted signal;
▪ Color space: Auto / RGB / YCbCr 4:4:4 / YCbCr 4:2:2 - The outgoing
signal color space can be selected by a drop-down menu;
INFO: The color space conversion supports resolutions up to
1600×1200@60Hz. When the pixel clock frequency is above
170MHz, the conversion does not execute, and the original content
will be transmitted.
▪ TPS mode: Auto / HDBaseT / Long reach / LPPF1 / LPPF2.
See more information about TPS modes in the
section.
▪ Frame Detector;
▪ Cable Diagnostics;
Reloading factory default settings for the selected port.
▪
5.5.5. Analog Audio Inputs
Port properties window of the AUDIO1 (Jack) input
Certain parameters of the analog audio input signal can be set as
TPS Interface
follows:
▪ Mute/unmute the port;
Lock/unlock the port;
▪
▪ Volume: from 0 dB to -52 dB (step 0.25 dB), from -54 dB to -66
dB (step 2 dB); -69 dB; -72 dB; -78 dB (default is 0 dB)
Balance: from 0 to 100, step 1 (default is 50 = center)
▪
Reloading factory default settings for the selected port.
▪
46