Query The Status Of Destination Port; Query The Video Crosspoint Setting; Switching Video Input; Query The Video Autoselect Settings - Lightware UMX-TPS-TX100 Series User Manual


  
7. LW3 Programmers' Reference
7.4.2. Query the Status of Destination Port
Command and Response
Î GET·/MEDIA/VIDEO/XP.DestinationPortStatus
pr·/MEDIA/VIDEO/XP.DestinationPortStatus=<out1_state>;<out2_state>;<...>;<out#_state>
Í
Parameters
<out#_state> The response contains 5 ASCII characters for each port. The first character indicates the
mute/lock state, the next 2-byte long HEX code showing the current state of the output port.
Example
Î GET /MEDIA/VIDEO/XP.DestinationPortStatus
Í pr /MEDIA/VIDEO/XP.DestinationPortStatus=M00BF
Legend
See at previous section.
Example and Explanation
M 0
0 0 0 0 0 0
Unlocked,
Muted
Reserved Reserved Reserved
7.4.3. Query the Video Crosspoint Setting
Command and Response
Î GET·/MEDIA/VIDEO/XP.DestinationConnectionList
pr·/MEDIA/VIDEO/XP.DestinationConnectionList=<in>
Í
Example
Î GET /MEDIA/VIDEO/XP.DestinationConnectionList
Í pr /MEDIA/VIDEO/XP.DestinationConnectionList=I1
0 B
0 0 1 0 1 1 1 1
No embedded Signal
Reserved Encrypted
audio presents
UMX-TPS-TX100 series – User's Manual
7.4.4. Switching Video Input
Command and Response
Î CALL·/MEDIA/VIDEO/XP:switch(<in>:<out>)
Í mO·/MEDIA/VIDEO/XP:switch
Example
Î CALL /MEDIA/VIDEO/XP:switch(I2:O1)
Í mO /MEDIA/VIDEO/XP:switch
Explanation
I2 port is connected to O1 port.
7.4.5. Query the Video Autoselect Settings
Command and Response
Î GET·/MEDIA/VIDEO/XP.DestinationPortAutoselect
pr·/MEDIA/VIDEO/XP.DestinationPortAutoselect=<out1_set>;<out2_set>;<...>;<out#_set>
Í
F The response shows the settings of each output one by one.
1 1
Parameters
Connected
Identifier
<out#_set>
Example
Î GET /MEDIA/VIDEO/XP.DestinationPortAutoselect
Í pr /MEDIA/VIDEO/XP.DestinationPortAutoselect=EL
Explanation
EL: the Autoselect is Enabled on output, selected mode is Last detect.
INFO: For more information about the Autoselect feature see
Parameter description Value
Two-letter code of the
E Autoselect is enabled.
Autoselect settings
D Autoselect is disabled.
1 letter
st
F First detect: the first active video input is selected.
Two-letter code of the Priority detect: always the highest priority active
P
Autoselect settings video input will be selected.
2 letter
nd
Last detect: always the last attached input is
L
switched to the output automatically.
The Autoselect Feature
77
Parameter value
section.