Rear View - Wp-Umx-Tps-Tx100 Series; Front View - Fp-Umx-Tps-Tx100 Series - Lightware UMX-TPS-TX100 Series User Manual


  
3. Product Overview
3.4. Rear View - WP-UMX-TPS-TX100 series
WP-UMX-TPS-TX120-US / WP-UMX-TPS-TX130-US /
WP-UMX-TPS-TX130-US-Plus
1
2
1 RS-232 3-pole Phoenix connector for controlling
connector the device with LDC or third-party control
systems, or third-party device control. Pin
assignment can be found in the
Connector section.
2 TPS output Locking RJ45 connector for HDBaseT
(PoE) signal transmission. Maximum CATx cable
distances can be found in the
Extension Distances
3 48V DC input Power the device remotely by a PoE-
compatible power injector (TPS-PI-1P1).
If the device has to be powered by a local
adaptor (PSU-48VP1), connect the output
to the 2-pole Phoenix connector on the rear
of the wall plate. See more details about
powering options in the
section or see all the available
Options.
3.5. Front View - FP-UMX-TPS-TX100 series
FP-UMX-TPS-TX120
2
3
4
3
5
6
FP-UMX-TPS-TX130
2
RS-232
3
TM
Maximum 4
section.
5
6
48V DC Connection
Powering
UMX-TPS-TX100 series – User's Manual
1
7
8
9
q
1
7
8
9
q
w
Input Status LEDs give feedback about the current status of
1
LEDs the unit and input signals. See the details in the
Front Panel LEDs section.
2 Audio Select Button for switching between audio sources. See
button the details in the Audio Select Button
3 Video Select Button for switching between video sources. See
button the details in the Video Select Button
4 Ethernet Locking RJ-45 connector for configuring the
device using Lightware Device Controller (LDC),
or upgrading it using Lightware Device Updater
(LDU). Any third-party control system can use
this port to control the device.
5 VGA input D-SUB connector for analog video signal.
Audio input 3.5 mm Jack connector for asymmetric analog
6
audio input signal.
Show Me Special functions can be reached using this
7
button button (firmware upgrade (bootload) mode,
DHCP settings, restore factory default settings,
condition launching in Event
Reset button Pushing the button reboots the unit.
8
9 IR detector IR Detector can sense IR light which can
be forwarded to the receiver side or use for
controlling functions.
q HDMI input HDMI connector for DVI video or HDMI video
and audio.
DisplayPort DisplayPort connector for DisplayPort audio/
w
input video signal.
25
section.
section.
Manager).