Lightware UMX-TPS-TX100 Series User Manual page 104


  
8. Firmware Upgrade
Upgrade Steps
Step 1. Select the firmware package.
Click on the Select Firmware Package button and navigate to the location where the LFP2 file of the device is
saved. When you click on the name of package, the preview of the release notes are displayed on the right
side.
Firmware file browser and the release notes window
After the package file is loaded, the list is filtered to show compatible devices only. The current firmware
version of the device is highlighted in orange if it is different from the version of the package loaded.
Filtered device list based on the selected firmware package
UMX-TPS-TX100 series – User's Manual
Step 2. Select the unit for upgrading.
Pick the device for upgrading. The selected line will be highlighted in green.
TIPS AND TRICKS: If you are not sure which device is connected to your controller device directly, use
the Identify me feature clicking on the
seconds. The feature helps to identify the device itself in the rack shelf or on the desk.
Step 3. Check the upgrade parameters.
ATTENTION! The default settings in the Parameters window should be fine for most cases. Please do not
modify them if it is not necessary.
Click on the Parameters button to configure the
firmware upgrade.
Backup and Restore settings
Restore device configuration: restore device
configuration from the backup file created at
the beginning of the update process.
Factory default: if it is selected, all user settings
and parameters will be cleared and the factory
default settings will be applied to the device
when the upgrade is done. See the whole list of
factory default settings of the endpoint device
in the Factory Default Settings
Once the parameters are set, click on the Apply
button to save the settings.
The unit is selected for upgrading
button. It makes the four front panel LEDs blink in green for 10

section.
104