Connecting Steps; Fp/Wp-Umx-Tps-Tx100 Series; Umx-Tps-Tx100 Series - Lightware UMX-TPS-TX100 Series User Manual


  
2. Installation
2.4. Connecting Steps
2.4.1. FP/WP-UMX-TPS-TX100 series
VGA laptop
VGA Audio

FP/WP-UMX-TPS-TX100 series

transmitter
Power
Power adaptor
CATx Connect the transmitter and a compatible receiver or the matrix input board by a CATx cable via the
TPS connectors.
VGA Connect the transmitter and the sources using the inputs and VGA / DVI-I / HDMI / DisplayPort
HDMI
cables.
DP
Audio Optionally connect an asymmetric audio device with unbalanced audio signal (e.g. a VGA laptop)
to the 2.5" TRS (jack) audio input port.
LAN Optionally connect the transmitter to a LAN network in order to control the device.
RS-232 Optionally connect a controller/controlled device (e.g. relay box) to the RS-232 port.
Power
See powering options in the next section.
HDMI laptop
MacBook
HDMI DP
W W P P - - U U M M X X - - T T P P S S - - T T X X 1 1 3 3 0 0 - - U U S S
VIDEO AUDIO SHOW
SELECT SELECT ME
CATx
Ethernet
INPUT STATUS
VGA AUDIO
DP DP
HDMI HDMI
Autoselect TPS LINK IR
VIDEO AUDIO RESET
VGA IN AUDIO IN DP IN HDMI IN
Compatible
receiver or
input board
RS-232 LAN
Relay box Ethernet
UMX-TPS-TX100 series – User's Manual
2.4.2. UMX-TPS-TX100 series
VGA laptop HDMI laptop
VGA Audio

UMX-TPS-TX100 series

transmitter
Power
Power adaptor Relay box
CATx
Connect the the transmitter and a compatible receiver or the matrix input board by a CATx cable via
the TPS connectors.
VGA Connect the transmitter and the sources using the inputs and VGA / DVI-I / HDMI / DisplayPort
DVI cables.
HDMI
DP
Audio Optionally connect an asymmetric audio device with unbalanced audio signal (e.g. a VGA laptop)
to the 2.5" TRS (jack) audio input port.
Audio Optionally connect a symmetric audio device with balanced audio signal (e.g. a media player) to
the 5-pole Phoenix audio input port. See the wiring guide for the connector in the
Wiring Guide section.
IR Optionally for Infrared control:
- Connect the IR emitter to the IR OUT port of the device.
- Connect the IR detector to the IR IN port of the device.
LAN Optionally connect the transmitter to a LAN network in order to control the device.
RS-232
Optionally for RS-232 control: connect a controller/controlled device (e.g. touch panel) to the RS-232 port.
GPIO Optionally connect a controller/controlled device (e.g. relay box) to the GPIO port.
Power See powering options in the next section.
PC MacBook
HDMI DVI DP
CATx
VGA Audio1 HDCP RESET
HDMI HDMI Autoselect
DP DP DVI-A Video
DVI-D DVI-D Audio2
VIDEO AUDIO VIDEO AUDIO SHOW
VGA IN AUDIO1 IN HDMI IN DP IN INPUT STATUS SELECT SELECT ME
GPIO RS-232 LAN
Touch panel Ethernet
21
Media player
Audio
Compatible
receiver or
input board
IR
Infrared
Audio Cable