Factory Default Settings; Content Of Backup File - Lightware UMX-TPS-TX100 Series User Manual


  
11. Appendix
11.2. Factory Default Settings
Parameter
Crosspoint settings
Video I1 (VGA in)
Audio I1 (Analog audio in 1)
Video port settings
HDCP Enabled
Autoselect Disabled
Emulated EDID on analog video Factory #89: Universal Analog
inputs EDID
Emulated EDID on digital video Dynamic #1: Copy EDID from
inputs connected sink device.
Test pattern mode Auto
Test pattern resolution 640x480p
Test pattern color (RGB code) #7F7F7F (grey)
Test pattern resolution on
640x480p
Testpattern input (I6)
Test pattern color (RGB code) on
#108020 (green)
Testpattern input (I6)
Output signal type Auto
Output HDCP mode Auto
Power 5V mode Always on
Color space Auto
TPS mode Auto
Analog audio port settings (I1 and I5)
Volume 0.00 dB (100%)
Balance 50 (center)
Network settings
IP address 192.168.0.100
Subnet mask 255.255.255.0
Static gateway 192.168.0.1
DHCP Disabled
LW2 port number 10001
LW3 port number 6107
HTTP port number 80
Setting/Value
Control protocol
Baud rate
Databits
Parity
Stopbits
Operation mode
Command injection port nr. - Local 8001
Command injection port nr. - TPS
Command injection status
Comm. inj. input port nr. - Local
Comm. inj. output port nr. - Local
Comm. inj. input port nr. - TPS
Comm. inj. output port nr. - TPS
Output level
Direction
UMX-TPS-TX100 series – User's Manual
Parameter Setting/Value
RS-232 settings
LW2
57600
8
None
1
Pass-through
8002
IR port settings
Enabled
9001
9002
9003
9004
GPIO port settings
High
Input
11.3. Content of Backup File
The backup file contains numerous settings and parameters saved
from the device. When the file is uploaded to a device, the followings
will be overwritten:
Analog video input ports (VGA, DVI-A)
Horizontal position, Vertical position, Active horizontal size, Active
vertical size, Total horizontal size, Pixel phase
Test pattern mode, Test pattern resolution, Test pattern color
Digital video input ports (HDMI, DP, DVI-D)
Video port name, Audio port name, HDCP setting
Test pattern mode, Test pattern resolution, Test pattern color
TPS output port
Port name, HDCP mode, HDMI mode, Power +5V mode, Color space
setting
Analog audio input ports
Port name, Volume, Balance
Crosspoint settings
Video crosspoint settings, audio crosspoint settings
Autoselect (enable/disable, delay settings, priority list)
Mute/lock state of video ports, Mute/lock state of audio ports
Serial ports (local and TPS)
RS-232 mode, Control protocol, Baud rate, Data bits, Stop bits, Parity
Port name and Command Injection (CI) port number
IR port
Port status (enable / disable), Code length, Repetition code,
Modulation state
Input port name, Output port name
CI status (enable / disable), CI port number
Network settings
DHCP status (enable / disable), Static IP address, Network mask,
Gateway address, LW2/LW3/HTTP port nr
Further settings
Device label, Control lock
User presets (U1-U32), User EDID data (U1-U15), Event Manager:
settings of all Events (E1-E20)
GPIO port configuration (pin 1-7)
115