Ethernet Port; Dc +12V Connection; Connector - Lightware HDMI-TPS-TX210 User Manual

2.5.5. Ethernet port

The Ethernet port can be connected to a LAN hub, switch or router by a CATx cable.
However both cable types (straight or cross) are supported and handled by the device,
below pin assignment is recommended.
OFF
Blink
ON

2.5.6. DC +12V connection

The transmitters have a locking DC connector to establish robust and safe power
connection. After plugging it in, turn the plug clockwise as you can see in the picture below.
Do not forget to turn the plug counterclockwise before disconnecting the power adaptor.
Always use the supplied +12V power adaptor or Lightware's rack mountable power supply.
Warranty void if damage occurs due to use of a different power source.
2.5.7. RS-232 connector
Most of the transmitters contain a 3-pole Phoenix connector, which is used for RS-232
serial connection. The transmitter has pass-through function, or can be remote controlled.
Compatible plug type
Phoenix® Combicon series (3.5mm pitch, 3-pole)
Type: MC 1.5/3-ST-3.5, order nr.: 691361100003 (Würth)
Section 2. Controls and connections
LED1 (green) LED2 (yellow)
10 Mbit/s not linked
- activity
100 Mbit/s no activity
LED2 LED1
8 1
Figure 2-2. RJ45 connector and pin assignments for Ethernet
Figure 2-3. Locking DC connector
1 2
Figure 2-4. RS-232 connector pin assignments
Pin nr.
1
2
3
4
5
6
7
8
Pin nr. Signal
Ground
1 TX data
2 RX data
HDMI-TPS-TX200 series
User's Manual
Name Wire color
TX + Green stripe
TX - Green
RX + Orange stripe
Not used Blue
Not used Blue stripe
Rx - Orange
Not used Brown stripe
Not used Brown
Page 21 / 122