Ir Interface; Technical Background; Ir Signal Transmission - Example 1; Ir Signal Transmission - Example 2 - Lightware UMX-TPS-TX100 Series User Manual


  
3. Product Overview
3.15. IR Interface
ATTENTION! For the complete usage attach an IR emitter unit to the IR OUT and an IR detector unit to the
IR IN connectors.
3.15.1. Technical Background
The Infrared signal transmission is similar to the serial data communication. The transmitter contains
dedicated IR I/O connection and also can transmit/receive IR signal via the TPS interface. The signal is in
pronto HEX format in both cases.
IR in
IR out
Block diagram of the IR interface - UMX-TPS-TX100 series transmitters
IR in
(built-in
sensor)
CPU
Block diagram of the IR interface - WP/FP-UMX-TPS-TX100 series transmitters
The most trivial usage of the IR interface is the transparent mode: signal received or sent on local IR ports
are transmitted directly on the TPS IR link port and vica versa. Beside of this there is an IR recognizer in the
device where you can assign actions in Event Manager for. The third option is the command injection mode
(like at serial interface in the previous section) where you can send IR commands over LAN. Command
injection mode can be turned on and off by input/output ports.
IR recognizer
for Event
Manager use
TCP / IR LAN
converter port
TPS / IR TPS
converter IR link
CPU
IR recognizer
for Event
Manager use
TCP / IR LAN
converter port
TPS / IR
TPS
converter IR link
UMX-TPS-TX100 series – User's Manual
INFO: All settings are available in the LDC software, see settings in the
INFO: The modulation of output IR signal can be turned off or on by LW3 command, see details in the
Enable/Disable Output Signal Modulation
3.15.2. IR Signal Transmission - Example 1
Blu-ray player
The Concept
An IR detector is attached to the Infrared input port of the TPS receiver and IR signals are sent by the Remote
controller. The TPS Receiver is connected to an UMX-TPS-TX100 series transmitter built with IR output port
via TPS line.
Settings:
Set the TPS IR link of the Transmitter to Transparent mode. IR signals are received over the local IR input port
of the Receiver by the Remote controller. The signals transmitted further over the TPS line to the Transmitter
which can control the Blu-ray player via an IR emitter.
3.15.3. IR Signal Transmission - Example 2
Remote controller WP-UMX-TPS-TX100
The Concept
The built-in IR detector of the Wallplate transmitter receives the IR signals from the Remote controller. The
signal is transmitted via the TPS line to the TPS receiver. In this way the Remote controller can control the the
Projector via the Wallplate transmitter.
Infra Tab
section.
IR OUT TPS OUT IR IN
VGA Audio1 HDCP RESET
HDMI HDMI Autoselect
DP DP DVI-A Video
DVI-D DVI-D Audio2
VIDEO AUDIO
VIDEO AUDIO SHOW
VGA IN AUDIO1 IN HDMI IN DP IN INPUT STATUS SELECT SELECT ME
UMX-TPS-TX100 series transmitter TPS receiver
TPS OUT IR OUT
W W P P - - U U M M X X - - T T P P S S - - T T X X 1 1 3 3 0 0 - - U U S S
VIDEO AUDIO SHOW
SELECT SELECT ME
Ethernet
INPUT STATUS
VGA AUDIO
DP DP
HDMI HDMI
Autoselect TPS LINK IR
VIDEO AUDIO RESET
VGA IN AUDIO IN DP IN HDMI IN
TPS receiver
series transmitter
34
section.
Remote controller
Projector