Table of Contents
Advertisement
Menu Navigation
2.1 Input/Output Status [momentary display]
1- From main display press Down arrow key to select
desired sensor
2- Use Right arrow key to momentarily see sensor
information
3- Use Left arrow key to momentarily see any output that
is tied to the selected input
4- Use ESC key to Exit
Note: The momentary information will remain on the
display as long as you hold down the arrow key
2.2
Modifying the 'Home' Screen
1- To set (modify) the Home
Screen press MENU
2- Use Up/Down Arrows to
navigate to System then press OK
3- Scroll to Diagnostic then
press OK
4- Scroll to System Diagnostic
then press F1, ADJUST
5- Use UP/Down Arrow keys to
select what to display on Top, Left
OLED Screen (maximum of six
parameters can be displayed on
OLED) then press F1 SELECT, you
should see a square box appear in
front of your selection.
6- Press F2, NEXT. "Mid, Left"
should appear on the screen, use
UP/Down Arrow keys to select what
to display in the middle row, left
position, then press F1, NEXT, you
should see a square box appear in
front of your selection
7- Continue the process for the
four remaining choices, if desired.
8- Press ESC (Escape) when
done.
Page 8 of 102
Advertisement
Table of Contents
