Setting The [Control] - ProMinent DULCOMETER Assembly And Operating Instructions Manual

10

Setting the [Control]

User qualification: trained user, see
n
Continuous display ➨
Settings for [Channel 2]
In its 2-channel version, the controller has two measurement channels. This descrip‐
tion for [Channel 1] applies correspondingly for the settings in [Channel 2]. The pro‐
cedure for making the settings for the channel in question is identical, however the
parameters to be set may be different. Differences are pointed out and are also
described.
NOTICE!
Possible data loss
If you change measured variables in the
'Configuration of measured variables' on page 50 , all settings in the [Measurement]
[Control] menus are reset to their factory settings (default values). You then
and
have to make the settings against in the
The operator is responsible for the correct set-up of the controller.
Prerequisites for the [Control] set-up:
The following settings are necessary for the [Control] set-up: If you have not yet
made the settings, do this now.
Specify all the measured variables and the necessary settings in the
–
[Measurement] menu, see Ä Chapter 8 'Configuration of measured variables'
on page 50
Specify all the intended actuators for the control task: You can find specifications
–
for the relevant electrical connections and settings in the menus
[Pumps], see Ä Chapter 12 'Setting the [Pumps]' on page 120
–
[Relays], see Ä Chapter 13 'Setting the [Relays]' on page 123
–
[mA outputs], see Ä Chapter 15 'Setting the [mA outputs]' on page 130
–
Actuators (regulator control elements) are for example metering pumps, solenoid
valves, motorised butterfly valves etc.
Ä Chapter 4.4 'Users' qualifications' on page 21
[Control] ➨
➨ or
[Measurement] menu, see Ä Chapter 8
[Measurement] and [Control] menus.
Setting the [Control]
[Control]
97