Character Expansion Settings - Star Line Thermal/Dot Printer Specifications

3-3-2)

Character Expansion Settings

ESC i n1 n2
[Name] Set/cancel the double wide/high
[Code] ASCII
Hexadecimal
Decimal
[Defined Area] Thermal
Slip
Validation
[Initial Value] Thermal
Slip
Validation
[Function] Specifies/cancels double high/wide for ANK characters and Kanji characters.
This command is ignored if either n1 or n2 is outside of the defined area.
<Thermal>
n1
0, 48 Cancel expanded high
1, 49 Specifies 2x expansion
2, 50 Specifies 3x expansion
3, 51 Specifies 4x expansion
4, 52 Specifies 5x expansion
5, 53 Specifies 6x expansion
n2
0, 48 Cancel expanded wide
1, 49 Specifies 2x wide expansion
2, 50 Specifies 3x wide expansion
3, 51 Specifies 4x wide expansion
4, 52 Specifies 5x wide expansion
5, 53 Specifies 6x wide expansion
<Slip>, <Validation>
n1
0, 48
1 ≤ n1 ≤ 5, 49 ≤ n1 ≤ 53
n2
0, 48
1 ≤ n2 ≤ 5, 49 ≤ n2 ≤ 53
However, in standard specifications, only the line feed amount is doubled for font configurations of 6
x 12 IBM block graphic characters.
When slip or validation is selected, and more than double is specified, printing is doubled for every
setting.
Setting more than triple is valid after switching to thermal.
(Note) The settings using this command are valid for all stations and modes.
STAR Line Mode Command Specifications
ESC i n1 n2
1B 69 n1 n2
27 105 n1 n2
: 0 ≤ n1 ≤ 5, 48 ≤ n1 ≤ 53("0" ≤ n1 ≤ "5"), 0 ≤ n2 ≤ 5, 48 ≤ n2 ≤ 53("0" ≤ n2 ≤ "5")
: 0 ≤ n1 ≤ 5, 48 ≤ n1 ≤ 53("0" ≤ n1 ≤ "5"), 0 ≤ n2 ≤ 5, 48 ≤ n2 ≤ 53("0" ≤ n2 ≤ "5")
: 0 ≤ n1 ≤ 5, 48 ≤ n1 ≤ 53("0" ≤ n1 ≤ "5"), 0 ≤ n2 ≤ 5, 48 ≤ n2 ≤ 53("0" ≤ n2 ≤ "5")
: n1 = 0 (Double high cancelled), n2 = 0 (Double wide cancelled)
: n1 = 0 (Double high cancelled), n2 = 0 (Double wide cancelled)
: n1 = 0 (Double high cancelled), n2 = 0 (Double wide cancelled)
Expanded high
Expanded wide
Cancel expanded high
Specifies 2x expansion
Cancel expanded wide
Specifies 2x wide expansion
Expanded high
Expanded wide
3-11
Rev. 0.00