Table of Contents
Advertisement
ESC * r V m n NUL
[Name]
Execute external buzzer drive
[Code]
ASCII
Hexadecimal
Decimal
[Defined Area]
Thermal
Slip
Validation
[Initial Value]
Thermal
Slip
Validation
[Function]
<Thermal>
Repeatedly drives the buzzer according to the ON/OFF conditions set by the external buzzer drive
pulse condition command ESC GS EM DC1 m n1 n2.
m specifies the buzzer drive terminal to drive.
m
49
Buzzer drive terminal 1
50
Buzzer drive terminal 2
Specifies the number of times to repeat buzzer drive with n.
Buzzer cannot ring while printer is printing.
This command is prohibited for use for anything other than ringing the buzzer.
(When this command is used for the drawer drive on models equipped with an external device termi-
nal, it will be damaged, so it is absolutely prohibited.) )
The buzzer can be stopped by pressing the FEED switch or the RELEASE switch while the buzzer is
ringing, or opening the receipt cover or the slip cover.
It is necessary to set the conditions prior to entering raster mode using the external buzzer drive
pulse conditions command ESC GS EM DC1 m n1 n2.
n is a decimal description (max. 255 digits) using ASCII characters.
[Ex.:]
Drive Pulse
Print Operation
<Slip>, <Validation>
Use prohibited.
STAR LIne Mode Command Specifications
ESC
*
r
V
1
1B
2A
72
56
31
27
42
114
86
49
:
m = 49, 50, 1 ≤ n ≤ 20
:
-
:
-
:
-
:
-
:
-
Buzzer Drive Terminals
ON
OFF
OFF
ON
(Note) If the off time is set to 0 (zero), it is possible to ring the buzzer
continuously for the amount of n1. For example, if on = 5 seconds, off = 0,
and n1 = 20 times, the buzzer will ring for 100 seconds.
n
NUL
n
0
n
0
n1 = 8
Printing/Paper Feed Prohibited
3-104
Rev. 0.00
Advertisement
Table of Contents
