Star Line Thermal/Dot Printer Specifications page 77

ESC GS EM DC1 m n1 n2
[Name] Set external buzzer drive pulse condition
[Code] ASCII ESC
Hexadecimal
Decimal
[Defined Area] Thermal
Slip
Validation
[Initial Value] Thermal
Slip
Validation
[Function] Set external buzzer drive pulse condition.
m specifies the buzzer drive terminal that sets the condition.
m Buzzer Drive Terminals
1, 49 Buzzer drive terminal 1
2, 50 Buzzer drive terminal 2
n1 specifies the energizing time; n2 specifies the delay time.
• Energizing time = 20 msec x n1
• Delay time = 20 msec x n2
Drive Pulse
Print Operation
The drive of the external buzzer set by this command is performed by ESC GS EM DC2 m n1 n2.
The set value is not initialized by ESC @, or CAN.
(Note) The settings using this command are valid for all stations and modes.
STAR Line Mode Command Specifications
GS EM DC1
1B 1D 19 11
27 29 25 17
: 1 ≤ m ≤ 2, 49 ≤ m ≤ 50, ("1" ≤ m ≤ "2")
0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
: 1 ≤ m ≤ 2, 49 ≤ m ≤ 50, ("1" ≤ m ≤ "2")
0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
: 1 ≤ m ≤ 2, 49 ≤ m ≤ 50, ("1" ≤ m ≤ "2")
0 ≤ n1 ≤ 255, 0 ≤ n2 ≤ 255
: n1 = 0, n2 = 0
: n1 = 0, n2 = 0
: n1 = 0, n2 = 0
ON
OFF
m n1 n2
m n1 n2
m n1 n2
20 × n1 (msec) 20 × n2 (msec)
(Energizing Time) (Delay Time)
Printing and Paper Feed Prohibited
3-65
Rev. 0.00