Table of Contents
Advertisement
ESC u n
[Name]
Specify two-byte 16 x 16 dot Kanji character (Single density/double density)
[Code]
ASCII
Hexadecimal
Decimal
[Defined Area]
Thermal
Slip
Validation
[Initial Value]
Thermal
Slip
Validation
[Function]
<Thermal>
Only setting is valid
Setting is valid after switching to slip or validation.
<Slip>, <Validation>
Specifies two-byte 16 x 16 dot Kanji character (Single density/double density) (* : See "Relationship
of Japanese Character Size Selection."
n
0, 48
Specify two-byte 16 x 16 dot [double density] Japanese characters
When two-bytes is selected, they become four-pass characters (state (A) to state (B))
Dots continuous horizontally are printing.
Sets to the 4 x expanded character mode by combining with ESC x 0 (Specify expanded
Japanese characters) (state (A) → state (D))
1, 49
Specify two-byte 16 x 16 dot Kanji characters (single density).
When two-bytes is selected, they become two-pass characters (state (B) to state (A))
Dots continuous horizontally are thinned for printing.
Sets to the vertical expanded character mode by combining with ESC x 0 (Specify expanded
Kanji characters) (state (B) → state (C))
When page mode is selected, only setting is valid
Setting is valid after switching to line mode.
STAR Line Mode Command Specifications
ESC
u
n
1B
75
n
27
117
n
:
-
:
n = 0, 1, n = 48, 49 ("0," "1")
:
n = 0, 1, n = 48, 49 ("0," "1")
:
-
:
Specify two-byte 16 x 16 dot Kanji characters (single density).
:
Specify two-byte 16 x 16 dot Kanji characters (single density).
State Transition
3-79
Rev. 0.00
Advertisement
Table of Contents
