Table of Contents
Advertisement
ESC s n1 n2
[Name]
Set two-byte Kanji characters left/right spaces
[Code]
ASCII
Hexadecimal
Decimal
[Defined Area]
Thermal
Slip
Validation
[Initial Value]
Thermal
Slip
Validation
[Function]
Adds n1 dot left space and n2 dot right space to Kanji characters.
This command is ignored for models not equipped with Chinese fonts (for overseas) and when the
specification for the location of use is specified as SBCS (single byte countries) by the memory
switch.
See each printer's product specifications manual for details on the memory switch settings.
<Slip>, <Validation>
The values of n1 and n2 when using two-byte 8 x 16, two-byte 16 x 16 and double-tall 8 x 16 charac-
ters correspond to the n1 and n2 values for double high/double wide 16 x 16 characters.
If the Japanese character size including the right and left spaces (n1 + character width + n2) ex-
ceeds the print region, printing will not be possible and a question mark ("?") will be printed instead.
When page mode is selected, only setting is valid
Setting is valid after switching to line mode.
(Note) The settings by this command are valid for all stations.
STAR Line Mode Command Specifications
ESC
s
n1
n2
1B
73
n1
n2
27
115
n1
n2
:
0 ≤ n1 ≤ 7, 48 ≤ n1 ≤ 55 ("0" ≤ n1 ≤ "7")
0 ≤ n2 ≤ 15, 48 ≤ n2 ≤ 57 ("0" ≤ n2 ≤ "9"), 65 ≤ n2 ≤ 70 ("A" ≤ n2 ≤ "F")
:
0 ≤ n1 ≤ 7, 48 ≤ n1 ≤ 55 ("0" ≤ n1 ≤ "7")
0 ≤ n2 ≤ 15, 48 ≤ n2 ≤ 57 ("0" ≤ n2 ≤ "9"), 65 ≤ n2 ≤ 70 ("A" ≤ n2 ≤ "F")
:
0 ≤ n1 ≤ 7, 48 ≤ n1 ≤ 55 ("0" ≤ n1 ≤ "7")
0 ≤ n2 ≤ 15, 48 ≤ n2 ≤ 57 ("0" ≤ n2 ≤ "9"), 65 ≤ n2 ≤ 70 ("A" ≤ n2 ≤ "F")
:
Memory switch setting
:
Memory switch setting
:
Memory switch setting
3-75
Rev. 0.00
Advertisement
Table of Contents
