Table of Contents
Advertisement
ESC C n
[Name]
Set page length to n lines
[Code]
ASCII
Hexadecimal
Decimal
[Defined Area]
Thermal
Slip
Validation
[Initial Value]
Thermal
Slip
Validation
[Function]
<Thermal>
The position whereat this command is processed is considered the top of the page and sets the
page length to (current form feed amount x n).
This command cancels the bottom margin setting when setting page length.
The page length set using this command is unaffected by changing the form feed amount later.
Moving to the top of the page is performed using the following commands.
• Form feed command (FF):
• Cutter command (ESC d n): Sets cutter position at top of page.
• Raster command (ESC * r B): Top of page when raster mode ends.
• Error cancel operations:
<Slip>, <Validation>
Only setting is valid
Setting is valid after switching to thermal.
STAR Line Mode Command Specifications
ESC
C
n
1B
43
n
27
67
n
:
1 ≤ n ≤ 127
:
-
:
-
:
(Form feed amount initial value x 42)
:
-
:
-
Execute form feed
Sets error cancel operation end position at the top of the page.
3-33
Rev. 0.00
Advertisement
Table of Contents
