Table of Contents
Advertisement
ESC 1
[Name]
(Thermal) Specify 3 mm line feed amount/(Slip) specify 7/72 inch line feed amount
[Code]
ASCII
Hexadecimal
Decimal
[Defined Area]
Thermal
Slip
Validation
[Initial Value]
Thermal
Slip
Validation
[Function]
<Thermal>
Specifies the line feed amount to 3 mm.
<Slip>, <Validation>
Specifies the line feed amount to 7/72 in.
Line feed amounts can be set independently for both line mode and page mode.
ESC J n
[Name]
(Thermal) n/4 mm line feed/(Slip) execute n/72 line feed one time
[Code]
ASCII
Hexadecimal
Decimal
[Defined Area]
Thermal
Slip
Validation
[Initial Value]
Thermal
Slip
Validation
[Function]
Execute paper feed.
If print data exists in the line buffer, it prints that data.
This paper feed amount is unaffected even if there are vertical expanded characters in one line.
The single line feed amount setting value is not changed by this command.
<Thermal>
Executes a n/4mm paper feed.
Using this command will intermittently feed paper, therefore, it is normally recommended that this
command not be used.
(Currently set line feed amount –n/4 mm) portion is not printed.
<Slip>, <Validation>
Executes a n/72 in paper feed.
STAR LIne Mode Command Specifications
ESC
1
1B
31
27
49
:
-
:
-
:
-
:
Memory switch setting
:
1/6 inch
:
1/6 inch
ESC
J
n
1B
4A
n
27
74
n
:
1 ≤ n ≤ 255
:
1 ≤ n ≤ 255
:
1 ≤ n ≤ 255
:
-
:
-
:
-
3-28
Rev. 0.00
Advertisement
Table of Contents
