Table of Contents
Advertisement
ESC Q n
[Name]
Set right margin
[Code]
ASCII
Hexadecimal
Decimal
[Defined Area]
Thermal
Slip
Validation
[Initial Value]
Thermal
Slip
Validation
[Function]
Uses the left edge as a standard to set the print region as (current ANK character pitch x n).
Setting this command partway will take affect from the next line.
Character spacing is included in the character pitch but is unaffected by expansion settings.
The left margin set using this command is unaffected by changing the character pitch.
<Thermal>
The right edge is also the reference for upside-down printing.
This command is ignored if settings are for a printing region less than 36 mm.
<Slip>, <Validation>
The left edge is also the reference for upside-down printing.
The print region within the defined range must be at least a minimum of 18 dots for the right margin.
If the printable region as set by the left and right margins is smaller than one character, including
the space between characters, printing is not possible. A question mark (?) is printed instead of the
character.
(*1)
(when character spacing = 0)
When page mode is selected, only setting is valid
Setting is valid after switching to line mode.
Left Margin
STAR LIne Mode Command Specifications
ESC
Q
n
1B
51
n
27
81
n
:
0 ≤ n ≤ 255
:
2 ≤ n ≤ maximum printable digits ≤ 255
:
2 ≤ n ≤ maximum printable digits ≤ 255
:
-
:
Maximum printable digits
:
Maximum printable digits
More than four characters of 7 x 9 fonts; more than three characters of 5 x 9 fonts (2P=1)
Printable Region
Print Region
Right Margin
3-38
Rev. 0.00
Advertisement
Table of Contents
