Bluetooth Settings (For Bluetooth Interface Models Only ) - Star TSP100III Series Hardware Manual

3-7. Bluetooth Settings
RST button
RST
LED
Pair the printer with the master device by following the procedure below.
3-7-1. Pairing using SSP (Simple Secure Pairing) [Default]
(1) Working on the master device, tap [Settings] and set [Bluetooth] to ON.
(2) After turning the printer's power switch on, press and hold the PAIR button on the rear
interface of the printer for 5 seconds or more, and then release it. The LED will flash green.
(3) Pairing will be possible for 60 seconds from when the LED begins flashing green.
During this time, execute "Search for devices" from the master device and tap the relevant
device from the displayed list.
Device name: Star Micronics (default)
(4) In an iOS device, after pairing, the LED will automatically begin flashing blue, and the
printer will be automatically connected. In an Android device, the LED turns blue only
while data is sent.
(5) Connect to the printer from the master device application and perform printing. If the
printing is successful, the pairing process has been completed.
(For Bluetooth Interface Models only )
PAIR button
PAIR
< iOS >
PAIR button
Flashing green LED
< LED >
Indicates the status of the Bluetooth interface.
Green (on): Not connected.
Green (flashing): Ready to start pairing.
Blue (on): Connected.
Purple (flashing): Auto connection ON.
– 19 –
< Android >