Table of Contents
Advertisement
3-5)
Black Mark Related Command Details
The following commands control top of form functions using black mark paper.
The following commands are effective only when black mark is set to be effective.
ESC d n
[Name]
Auto - cutter:
[Code]
ASCII
Hexadecimal
Decimal
[Defined Area]
Thermal
Slip
Validation
[Initial Value]
Thermal
Slip
Validation
[Function]
<Thermal>
Executes the auto-cutter.
After auto-cutter is executed, the printer considers that to be the top of the page.
n
0, 48
Full cut at the current position.
Print data in line buffer is printed before a full cut.
This command is ignored if the printer is not equipped with an auto-cutter.
1, 49
Partial cut at the current position.
Print data in line buffer is printed before a partial cut.
This command is ignored if the printer is not equipped with an auto-cutter.
2, 50
After executing top of form, paper is fed to cutting position, then a full cut.
Print data in line buffer is printed before the operation described above.
This command is ignored if the printer is not equipped with an auto-cutter.
3, 51
After executing top of form, paper is fed to cutting position, then a partial cut.
Print data in line buffer is printed before the operation described above.
This command is ignored if the printer is not equipped with an auto-cutter.
(*) The auto-cutter function operates in the following ways on models that only have a full cut or a
partial cut.
• Models that perform only a full cut.:
• Models that perform only a partial cut.:
<Slip>, <Validation>
Three bytes ignored
STAR Line Mode Command Specifications
ESC
d
n
1B
64
n
27
100
n
:
0 ≤ n ≤ 3, 48 ≤ n ≤ 51 ("0" ≤ n ≤ "3")
:
-
:
-
:
-
:
-
:
-
Auto cutter
Executes a full cut when for instructions calling for a
partial cut.
Executes a partial cut when there are for instructions
calling for a full cut.
3-105
Rev. 0.00
Advertisement
Table of Contents
