Bosch Purion BUI210 Original Operating Instructions page 17

Code Cause
593 Configuration error
595, 596 Communication error
602 Internal battery fault while charging
602 Internal battery fault
603 Internal battery fault
605 Battery temperature error
605 Battery temperature error while charging Unplug the charger from the battery. Allow the battery to cool. If
606 External battery fault
610 Battery voltage error
620 Charger fault
640 Internal battery fault
655 Multiple battery faults
656 Software version error
7xx Transmission fault
800 Internal ABS fault
810 Implausible signals from the wheel speed
sensor. Contact your Bosch eBike dealer.
820 Fault in the wire to the front wheel speed
sensor.
821 to 826 Implausible signals from the front wheel
speed sensor.
The sensor disc may be missing, defective
or fitted incorrectly; there is a significant
difference in diameter between the front
wheel and the rear wheel; extreme riding
situation, e.g. riding solely on the rear
wheel.
830 Fault in the wire to the rear wheel speed
sensor.
831 Implausible signals from the rear wheel
833 to 835 speed sensor.
The sensor disc may be missing, defective
or fitted incorrectly; there is a significant
difference in diameter between the front
Bosch eBike Systems
Corrective measures
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Check the wiring to the transmission and restart the system. If the
problem persists, contact your Bosch eBike dealer.
Unplug the charger from the battery. Restart the eBike system.
Plug the charger into the battery. If the problem persists, contact
your Bosch eBike dealer.
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
The eBike is outside of the permissible temperature range. Switch
off the eBike system and allow the drive unit to either cool down or
heat up to the permissible temperature range. Restart the system.
If the problem persists, contact your Bosch eBike dealer.
the problem persists, contact your Bosch eBike dealer.
Check the wiring. Restart the system. If the problem persists, con-
tact your Bosch eBike dealer.
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Replace the charger. Contact your Bosch eBike dealer.
Restart the system. If the problem persists, contact your Bosch
eBike dealer.
Switch off the eBike system. Remove then reinsert the battery. Re-
start the system. If the problem persists, contact your Bosch eBike
dealer.
Contact your Bosch eBike dealer so that they can perform a soft-
ware update.
Please observe the operating instructions provided by the trans-
mission manufacturer.
Contact your Bosch eBike dealer.
Contact your Bosch eBike dealer.
Contact your Bosch eBike dealer.
Restart the system and carry out a test ride lasting at least two
minutes. The ABS indicator light must go out. If the problem per-
sists, contact your Bosch eBike dealer.
Contact your Bosch eBike dealer.
Restart the system and carry out a test ride lasting at least two
minutes. The ABS indicator light must go out. If the problem per-
sists, contact your Bosch eBike dealer.
English – ​ 5
1 207 020 XBP | (14.05.2018)