Drive Diagnostics Via Keypad - Lenze 8400 StateLine C Hardware Manual

9.1.2

Drive diagnostics via keypad

Important operating parameters are measured by the controller. They can be displayed
with the keypad or PC.
Some operating data can be calibrated to be displayed or selected directly with the unit of
the process quantity (e.g. pressure, temperature, speed).
)
Note!
The calibration always affects all specified codes simultaneously.
Display of the controller status on the keypad
Icon
d
—
˜
™
š
›
¥
¦
§
œ
Ÿ
¡
¢
Display parameters
The parameters listed in the following table serve to query current states and actual values
of the controller for diagnostic purposes, e.g. by means of the keypad, via a bus system, or
using the »Engineer« (when an online connection to the controller has been established)
– In the »Engineer« parameter list and in the keypad these parameters are classified
in the Diagnostics category.
– A detailed description of these parameters can be found in the software manual
for StateLine C and HighLine C.
EDS84ASC552 EN 6.0
efesotomasyon.com - Lenze
Display of operating data, diagnostics
– If the keypad at the front of the controller is connected to the
diagnostic interface X6, the area  of the LCD displays the
controller status via different symbols.
Meaning
Controller is switched on.
Controller is enabled.
Application in the controller is stopped.
Quick stop is active.
Controller is inhibited.
Controller is ready to start
Speed controller 1 in the limitation
The set current limit is exceeded in motor
or generator mode
Pulse inhibit is active
System fault is active
Fault
Trouble
TroubleQSP
Warning is active
l
Diagnostics
Drive diagnostics via keypad
Note
à "SwitchedON" state
The power outputs are inhibited.
à
"ReadyToSwitchOn" state
The drive is torque−controlled.
The power outputs are inhibited.
à "Fault" state
à
"Trouble" state
à "TroubleQSP" state
à
"Warning" status display
9
165