Removing a USB hypervisor key
To remove a USB hypervisor key from the server, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the cover (see "Removing the cover" on page 145).
4. Push down the blue locking collar on the USB hypervisor connector to unlock it
5. Pull the hypervisor memory key out of the USB hypervisor connector.
6. If you are instructed to return the hypervisor memory key, follow all packaging
Note: You must configure the server not to look for the hypervisor USB drive. See
"Configuring the server" on page 234 for information about disabling hypervisor
support.
on page 133.
external cables.
from the connector.
instructions, and use any packaging materials for shipping that are supplied to
you.
Chapter 5. Removing and replacing server components
169