Table of Contents
Advertisement
SATA 0
6. Rotate the rear hard disk drive cage 2 outwards. Then, carefully pull the rear
hard disk drive cage 3 out of the chassis.
7. Remove the air baffle (see "Removing the air baffle" on page 148).
8. Find the rear hard disk drive detect pin of the hot-swap backplane (I
located near the system fan cage; then, disconnect from the rear hard disk drive
detect pin of the LED signal cable.
SATA 1
Chapter 5. Removing and replacing server components
SATA 0
SATA signal cable 0
Hot-swap backplane
power cable
SATA signal cable 1
SATA 1
2
C) cable
203
Advertisement
Table of Contents
