Removing The System Battery - IBM x3630 M3 7377 Problem Determination And Service Manual

Removing the system battery

Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To remove the battery, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Follow any special handling and installation instructions that come with the
3. Turn off the server and peripheral devices, and disconnect the power cord and
4. Remove the cover (see "Removing the cover" on page 145).
5. Remove the PCI riser-card assembly (see "Removing the PCI riser-card
6. Locate the battery on the system board.
142
IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
on page 133.
battery.
all external cables.
assembly" on page 150).