Table of Contents
Advertisement
Logging on to the Web interface
To log on to the Web interface to use the remote presence functions, complete the
following steps:
1. Open a Web browser on a computer that connects to the server and in the
2. Type the user name and password. If you are using the IMM for the first time,
3. On the Welcome page, type a timeout value (in minutes) in the field that is
4. Click Continue to start the session. The browser opens the System Status
Using the USB memory key for VMware hypervisor
The VMware hypervisor is available on server models that come with an installed
IBM USB Memory Key for VMware Hypervisor. The USB memory key installs in the
USB hypervisor connector on the system daughter board. Hypervisor is
virtualization software that enables multiple operating systems to run on a host
computer at the same time. The USB memory key is required to activate the
hypervisor functions.
Note: VMware 4.0 U1 does not support JBOD (Just a Bunch of Disks) hard disk
drives in a server with ServeRAID M1015 SAS/SATA adapter installed.
To start using the embedded hypervisor functions, you must add the USB memory
key to the startup sequence in the Setup utility.
To add the USB hypervisor memory key to the boot order, complete the following
steps:
1. Turn on the server.
2. When the prompt F1 Setup is displayed, press F1.
3. From the Setup utility main menu, select Boot Manager.
4. Select Add Boot Option; then, select Hypervisor. Press Enter, and then press
Address or URL field, type the IP address or host name of the IMM to which
you want to connect.
Notes:
a. If you are logging in to the IMM for the first time after installation, the IMM
defaults to DHCP. If a DHCP host is not available, the IMM uses the default
static IP address 192.168.70.125.
b. You can obtain the DHCP-assigned IP address or the static IP address from
the server firmware or from your network administrator.
The Login page is displayed.
you can obtain the user name and password from your system administrator. All
login attempts are documented in the event log. A welcome page opens in the
browser.
Note: The IMM is set initially with a user name of USERID and password of
PASSW0RD (passw0rd with a zero, not the letter O). You have read/write
access. For enhanced security, change this default password during the initial
configuration.
provided. The IMM will log you off the Web interface if your browser is inactive
for the number of minutes that you entered for the timeout value.
page, which displays the server status and the server health summary.
Note: Approximately 40 seconds after the server is connected to ac power, the
power-control button becomes active.
Esc.
Chapter 6. Configuration information and instructions
245
Advertisement
Table of Contents
