Removing An Adapter From The Pci Riser-Card Assembly - IBM x3630 M3 7377 Problem Determination And Service Manual

3. Install the screws to secure the PCI riser card to the PCI riser-card assembly.
4. Install any adapter that you removed (see "Installing an adapter on the PCI
5. Install the remote battery tray if you removed it (see step 4 on page 174 of the
6. Install the PCI riser-card assembly (see "Installing the PCI riser-card assembly"
7. Install the server cover (see "Installing the cover" on page 146).
8. Reconnect the external cables; then, reconnect the power cords and turn on the

Removing an adapter from the PCI riser-card assembly

This topic describes removing an adapter from a PCI expansion slot in the PCI
riser-card assembly. These instructions apply to PCI adapters such as video graphic
adapters, and network adapters.
To remove an adapter from a PCI expansion slot, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the cover (see "Removing the cover" on page 145).
156
IBM System x3630 M3 Type 7377: Problem Determination and Service Guide
riser-card assembly" on page 157).
"Installing a ServeRAID controller battery on the remote battery tray" on page
172 procedure).
on page 151).
peripheral devices and the server.
on page 133.
external cables.